I’m through this section now and the assembly of the next section so I found my answer:
One of the 100mm extrusions needs two holes drilled on the same side, using the drill guide hole marked “BED” from either end. I think it would be helpful for this section to include a step for that. These holes are used in 02. Z Frame Assembly / Step 5 Bed Carrier / 4th bullet
The latest manual shows preloading 6 nuts on the left.
I’m through this section now and the assembly of the next section so I found my answer:
One of the 100mm extrusions needs two holes drilled on the same side, using the drill guide hole marked “BED” from either end. I think it would be helpful for this section to include a step for that. These holes are used in 02. Z Frame Assembly / Step 5 Bed Carrier / 4th bullet
Can you clarify whether any holes get drilled in the 100mm extrusions?
The diagram shows the locating tool side hole marked “bed” but the instructions don’t show where that is used