Difficulty
Moderate
Steps
3
Time Required
User-Contributed Guide
This guide is not managed by the site's staff.
Tools
Parts
-
-
The instructions for building the Voron Pocketwatch Extruder is in a separate Assembly Manual & Guide. What follows is how to attach it to the Voron 0.
-
Attach the extruder mounting bracket as shown.
-
Before attaching the extruder in the next step, add about a 20mm piece of Bowden tube to the filament inlet. Push the tube in until it seats in the plastic.
-
-
-
Attach the extruder through the back panel into the Z vertical extrusion. Placing the printer on it's front face will let the nuts sit still while you attach the extruder. If you pre-installed the screws in a previous guide, attaching the extruder should be easier.
-
Cancel: I did not complete this guide.
3 other people completed this guide.
