Skip to main content
  1. The instructions for building the Voron Pocketwatch Extruder is in a separate Assembly Manual & Guide. What follows is how to attach it to the Voron 0.
    • The instructions for building the Voron Pocketwatch Extruder is in a separate Assembly Manual & Guide. What follows is how to attach it to the Voron 0.

    • Attach the extruder mounting bracket as shown.

    • Before attaching the extruder in the next step, add about a 20mm piece of Bowden tube to the filament inlet. Push the tube in until it seats in the plastic.

  2. Attach the extruder through the back panel into the Z vertical extrusion. Placing the printer on it's front face will let the nuts sit still while you attach the extruder. If you pre-installed the screws in a previous guide, attaching the extruder should be easier.
    • Attach the extruder through the back panel into the Z vertical extrusion. Placing the printer on it's front face will let the nuts sit still while you attach the extruder. If you pre-installed the screws in a previous guide, attaching the extruder should be easier.

Finish Line

3 other people completed this guide.

John Gilbert

Member since: 02/05/2020

1,744 Reputation

17 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 12

All Time: 1,601