You're viewing a previously published revision of this guide.  View latest revision

Older
Dec 09, 2019 - 01:12:36
Dec 23, 2019 - 02:12:25 Dec 12, 2019 - 01:12:50 Dec 10, 2019 - 07:12:08 Dec 10, 2019 - 06:12:45 Dec 10, 2019 - 06:12:39 Dec 10, 2019 - 06:12:39 Dec 10, 2019 - 06:12:33 Dec 09, 2019 - 03:12:57 Dec 09, 2019 - 03:12:45 Dec 09, 2019 - 03:12:36 Dec 09, 2019 - 03:12:56 Dec 09, 2019 - 03:12:39 Dec 09, 2019 - 03:12:37 Dec 09, 2019 - 03:12:07 Dec 09, 2019 - 03:12:02 Dec 09, 2019 - 03:12:41 Dec 09, 2019 - 03:12:58 Dec 09, 2019 - 03:12:05 Dec 09, 2019 - 03:12:54 Dec 09, 2019 - 03:12:33 Dec 09, 2019 - 03:12:54 Dec 09, 2019 - 03:12:16 Dec 09, 2019 - 03:12:31 Dec 09, 2019 - 03:12:51 Dec 09, 2019 - 03:12:24 Dec 09, 2019 - 03:12:52 Dec 09, 2019 - 03:12:22 Dec 09, 2019 - 03:12:08 Dec 09, 2019 - 03:12:58 Dec 09, 2019 - 03:12:32 Dec 09, 2019 - 03:12:23 Dec 09, 2019 - 03:12:13 Dec 09, 2019 - 03:12:05 Dec 09, 2019 - 03:12:47 Dec 09, 2019 - 01:12:36 Dec 09, 2019 - 01:12:34 Dec 09, 2019 - 12:12:01 Dec 09, 2019 - 12:12:43 Dec 09, 2019 - 12:12:43 Dec 09, 2019 - 12:12:51
Newer

How to Extruder Calibration (ESTEPS)

Written By: insurgus (and one other contributor)
  • Comments: 3
  • Favorites: 0
  • Completions: 1

Difficulty

Easy

Steps

2

Time Required

00:30:00

Sections

1

Flags

2

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

Private

Private

This guide will not appear in search results and can only be viewed by team members!

Quiz

0

    • Open your printer.cfg in your preferred editor

    • Located the [extruder] section

    • Take note of the config line “step_distance” ex step_distance: 0.001833

Author

with 1 other contributor

insurgus

Member since: 12/9/19

87,639 Reputation

24 Guides authored

View Statistics:

Past 24 Hours: 3

Past 7 Days: 11

Past 30 Days: 38

All Time: 15,812