You're viewing a previously published revision of this guide.  View latest revision

Older
Dec 09, 2019 - 03:12:47
Dec 23, 2019 - 02:12:25 Dec 12, 2019 - 01:12:50 Dec 10, 2019 - 07:12:08 Dec 10, 2019 - 06:12:45 Dec 10, 2019 - 06:12:39 Dec 10, 2019 - 06:12:39 Dec 10, 2019 - 06:12:33 Dec 09, 2019 - 03:12:57 Dec 09, 2019 - 03:12:45 Dec 09, 2019 - 03:12:36 Dec 09, 2019 - 03:12:56 Dec 09, 2019 - 03:12:39 Dec 09, 2019 - 03:12:37 Dec 09, 2019 - 03:12:07 Dec 09, 2019 - 03:12:02 Dec 09, 2019 - 03:12:41 Dec 09, 2019 - 03:12:58 Dec 09, 2019 - 03:12:05 Dec 09, 2019 - 03:12:54 Dec 09, 2019 - 03:12:33 Dec 09, 2019 - 03:12:54 Dec 09, 2019 - 03:12:16 Dec 09, 2019 - 03:12:31 Dec 09, 2019 - 03:12:51 Dec 09, 2019 - 03:12:24 Dec 09, 2019 - 03:12:52 Dec 09, 2019 - 03:12:22 Dec 09, 2019 - 03:12:08 Dec 09, 2019 - 03:12:58 Dec 09, 2019 - 03:12:32 Dec 09, 2019 - 03:12:23 Dec 09, 2019 - 03:12:13 Dec 09, 2019 - 03:12:05 Dec 09, 2019 - 03:12:47 Dec 09, 2019 - 01:12:36 Dec 09, 2019 - 01:12:34 Dec 09, 2019 - 12:12:01 Dec 09, 2019 - 12:12:43 Dec 09, 2019 - 12:12:43 Dec 09, 2019 - 12:12:51
Newer

How to Extruder Calibration (ESTEPS)

Written By: insurgus (and one other contributor)
  • Comments: 3
  • Favorites: 0
  • Completions: 1

Difficulty

Easy

Steps

2

Time Required

00:30:00

Sections

1

Flags

1

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

Quiz

0

    • Open your printer.cfg in your preferred editor

    • Located the [extruder] section

    • Take note of the config line “step_distance” ex step_distance: 0.001833

Author

with 1 other contributor

insurgus

Member since: 12/9/19

87,639 Reputation

24 Guides authored

View Statistics:

Past 24 Hours: 2

Past 7 Days: 12

Past 30 Days: 38

All Time: 15,811