Difficulty
Moderate
Steps
3
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
Pt100: Any two wire pt100 thermistor will do, including ones from e3d and Trianglelab
-
MAX31865 Board: You will need a Adafruit (or clone) MAX31865 amp board. You can buy the original here, or just search for a cheaper clone.
-
Dupont Jumper Cables: We will need 6 of them
-
-
-
Solder the pin header & the terminal blocks (obvious enough)
-
Bridge the pads marked with 2 wire (shown in picture) with solder.
-
-
-
Wire the PT100 wires into the center terminals (Picture 1)
-
Wire VIN to 5V and GND to Ground. Any free 5V and Gnd will do but I used Z+ limit switch outputs. (Picture 2)
-
