Difficulty
Moderate
Steps
7
Time Required
00:30:00 - 01:00:00
- 04 - X Carriage Assembly 7 steps
User-Contributed Guide
This guide is not managed by the site's staff.
-
-
Be careful not to crack the carriage pieces when inserting the bearings.
-
-
-
The M3 nuts for securing the toolhead can fall out. They can be added later if necessary. Or secure them in place with a short spare M3 bolt temporarily.
-
-
-
If the probe tabs did not print cleanly, you may need to substitute M2 hardware, clean up the part with a hobby knife, or reprint the pieces.
-
Almost done!
Finish Line
